There are a few posts out there to get basic support for django inside of bpython but I as far as I have seen they ignore the virtualenv stuff that most of us django users do.
virtualenv is a must when doing development on django projects, especially when you have several projects going on the same machine or you want to involve other developers. It allows for a clean environment with known versions of every package that is installed inside of the virtualenv.
The first part of this is a known hack or method (take your pick) to make bpython recognize the django project.
First you need to modify your ~/.bashrc or ~/.bash_profile (system dependent as to which is used) and add the following line to it:
What this does is it tells python to run ‘~/.pythonrc’ before it does anything else in the interpreter, this is a python specific thing not bpython specific thing.
Next you need to create the ~/.pythonrc file and put the following into it:
try: from django.core.management import setup_environ import settings setup_environ(settings) except: pass
Now if we didn’t care about virtualenv we’d be completely done. If you go the less strict route and don’t use –no-site-packages (the switch means that system wide packages are to be ignored in the virtualenv) then you will need to edit your bpython binary, most commonly located at /usr/bin/bpython or /usr/local/bin/bpython and change the shebang from:
(it may be /usr/local/bin/python)
This makes bpython use the value of the environment variable python instead of using a specific binary, the environment variable gets set by virtualenv so you are good to go after this.
If you use –no-site-packages then you will have to install bpython in each virtualenv that you want to use it in.
If you have any questions toss them in the comments or find me on freenode as Wraithan.